Is this possible?

[deazo]

 Hi, this is my second question for the day.
 When scanning folders for movie files, sometimes the tool makes a mistake, and even though the movie card already exists (without a file path), it proposes to "add a new movie".
 I know you can switch from "set file path/change file path" to "add a new movie", but can you do the reverse?

 I would like to switch the action from "add new movie" to "set file path", i would then choose the corresponding film card and point it to the file that was discovered by the scan.
 Is this possible?

Thanks again.

[nostra]

It is not possible, but it probably will be some time later.

[rick.ca]

...but it probably will be some time later.

I've been looking forward to that for some time now.

[deazo]

 OK I shall wait and pray then.